1 / 4
Descendants remix
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Sculptures
- License
- Creative Commons — Attribution
This is a great model from Rockytfox, but I didn't fancy printing it as it was, so I used TinkerCAD and split the gold tail in half but still printed with supports. I also put a hole in the bottom so I could put a tea light inside. I then used yellow cellophane over the D so it glows with the light rather than a bare LED shining through, or using a printed D which might be a little dim.
I also added the bite back in and printed it red to simplify the printing, it doesn't look as good but prints easier.
Print Settings
Printer Brand:
FlashForge
Printer:
Adventurer 3
Yes
Supports:
Yes
Filament:
Sunlu Pla Red and Gold
Category: Sculptures