Printbed-friendly Pry Bar
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a small pry bar for getting stubborn parts off the print bed. The hope is that the rounded fulcrum will ding…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 88
- Wydruki
- 0
- Wyświetlenia
- 1093
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
This is a small pry bar for getting stubborn parts off the print bed. The hope is that the rounded fulcrum will ding my bed less than a sharp angled one would. Works best on parts with some kind of chamfer or lip at the bottom.
I have a PEI bed, and print a lot of wide flat parts that can be a pain to get off. To avoid that first "sharp" layer from hotter/low printed first layers, I usually add a chamfer to the base of my designs. This pry bar gets under that chamfer and helps pop prints off.
Printed in PETG, 40% infill. I used 3 perimeter layers for extra strength in the tip. Printing with a smaller extrusion width will give you a sharper tip.
Category: 3D Printer Accessories