1 / 10
Beyblade / Bakuten Shoot Customize-Gear free shaft replacement — zdjęcie 1
1 / 10

Beyblade / Bakuten Shoot Customize-Gear free shaft replacement

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Redesign of the Customize-Gear that came with the (Takara) Beyblade Zeus. Optimized for 3D-Printing without supports

Ocena
0 / 5
Polubienia
24
Pobrania
170
Wydruki
0
Wyświetlenia
1788
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Update 14/08/24:
+ Improoved Left-SG-Part and added matching left AR-holder
--------------------------------------------------------------------------------------------

Update 11/08/24:
+ Renamed the files from “Zeus-EG” to “CG”
+ Added a Left-SG-Part 
+ Updated SG- and Bot-Part to fit other EG-bases
+ Made the Clamp-part thicker to improove the grip for other CEWs
--------------------------------------------------------------------------------------------

I designed a new version of the free-shaft Customize-Gear that came with the Beyblade Zeus (Takara version) so you can use it as a replacement on your Zeus or on every other existing EG-base.

It's optimized for FDM printing, needs no support and will not rub against the casing like the original did.

An M2-screw is used as the new shaft, so you don't need to have a genuine one.

I recommend printing the parts in PETG with 0.1mm layer height. 

 

To assemble it, you will need:

2x M2x12mm wafer-head or flat-head Screws

1x M2x16mm Screw (18mm ist fine too)

2x MR52ZZ-bearings (the same that fits in all other plastic-gen Beyblades)

 

Instructions:

1: Take the bot- and the Left/Right_SG-part and insert a ball bearing in the middle-hole of each one

2: Place the AR-holder on top of the Left/Right_SG and screw all three parts together with the two M2x12 screws in the outer holes.

3: Put the M2x16 screw from the top  into the assembly and screw the CEW-clamp from the bottom of the CG on it

4: You don't need to tighten the screw that much, just enough so that the clamp doesn't wobble around, but can still spin freely. If you want you can use a tiny bit of glue to secure it in place

5: Place the new CG in Zeus and use the CEW of your choice

Tagi