Controller mount for 8bitdo Pro 2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made to fit with 8bitdo Pro 2 controller. Does not cover the USB port.
- Ocena
- 4,75 / 5
- Polubienia
- 72
- Pobrania
- 588
- Wydruki
- 7
- Wyświetlenia
- 3235
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I am 95% sure it should fit with 8bitdo SN30 pro+ as well because they seem to have the same shape. If you have one, please print this and let me know if it works. For science!
These are meant to be attached to a flat surface with double-sided tape. Works very reliably if tape is used according to it's manual (apply pressure, use vertical lines, etc.) That said, if yours fall and break, I will take no responsibility. (seems obvious but who knows?)
I recommend using PETG because it is a little softer than ABS, which most of controllers are made of. I've had no signs of wear or scratches from these mounts on any of my controllers.
This is not a remix, but this controller mount is made to look similar to the mount for Xbox controller modeled by crazyg0od33. I've been using it for a while now and it is just perfect. Check it out if you also have an Xbox controller:
https://www.thingiverse.com/thing:1176663
LLAP
Update:
As per request, added a version mounted with 2 screws 11/32" head 5/32" shank (metric size 9mm head, 4mm shank)