1 / 3
250mm Air Conditioner Round Diffuser - Vented Face — zdjęcie 1
1 / 3

250mm Air Conditioner Round Diffuser - Vented Face

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a vented face replacement for the "Polyaire Round Ceiling Diffuser" for better heating during winter.

Ocena
0 / 5
Polubienia
4
Pobrania
43
Wydruki
0
Wyświetlenia
351
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a vented face replacement for the "Polyaire Round Ceiling Diffuser".

Printed in PLA or PETG, then fitted with an M8 threaded rod (10-15cm long) this will screw into the current thread of the roof vent. I've also used some epoxy to glue the rod into the vented face to ensure it doesn't un-screw.

This is 255mm diameter, so will print on a bed 255x255mm or larger (such as a Bambu Lab X1).

Information

Based on the fact that heat rises, this changes the diffuser from a ceiling spread pattern (horizontal) to a forced push to floor (vertical) for better heating during winter.

Ever been sitting on your lounge at night in winter and had your heat pump air conditioning on, and the ceiling and upstairs of your home is warm, but your body is cold?

This fixes that problem, by forcing the warm air directly downwards, the warmth spreads across the floor giving a more even heat.

Wind them tighter to make the flow more vertical, or open them up more to allow a mix of horizontal and vertical spread patterns.

Swap these in during winter, and put the standard ones back in summer.

Model

Happy for others to mix and use my model (or even improve it), just no commercial use - including no charging others for printing this or derivatives (I claim that copyright as I may get off my butt and sell these one day).

Available on onshape here.

Tagi