Captain Bruce Upgrade for 3D SETS Family - Ann & Bruce
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Warning
It is small parts (especially for this character), it is working on my side but sometime according your printer and your setting it could provide a poor result.
Definition
None.
Printing
Is required the same printer size than 3D SETS has defined.
Infill 15% and layer 0.15mm is fine.
It works without support.
For the cap, start with the black color, change color to yellow at 2.45mm, go back to black color at 3.5mm, change color to yellow at 3.8mm and switch to black at 4.85mm.
For the pipe change color to red at 3.80mm.
Build
Use 3D SETS Family universal connector.
No screw, may be some glue could be fine.
Cut to adjust the beard
Feedback
It is welcome, post your builds.
Remark
None.
Version
v1/v20240809 1st upload.