1 / 1
Shaft grip for racheting screwdriver from Action (Ø 7.3mm) — zdjęcie 1

Shaft grip for racheting screwdriver from Action (Ø 7.3mm)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Helps with turning the shaft of a ratcheting screwdriver for easier an quicker use

Ocena
0 / 5
Polubienia
2
Pobrania
14
Wydruki
0
Wyświetlenia
76
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

This grip is made to make it easier to use the ratcheting screwdriver by turning the shaft separately from the handle.

It is a press fit on the ratcheting screwdriver from the Action stores (shaft diameter of 7.3mm). The part can be scaled in the slicer to fit on basically any model.

 

I printed in PLA and for easier assembly i put the shaft in the freezer for 10-15 minutes. Even then it is a tight fit but with a few gentle hits from a hammer it goes on. It has to be this tight to keep it from slipping on the shaft.

 

Some extra info on the screwdriver: as the grip clearly won't fit over the wider end with the hex socket, you need to take the handle off. This model fortunately attaches its shaft with a common square socket which makes this very easy.

Keep this in mind if you use the part on another model as I'm not sure how common a detachable shaft is on these kind of screwdrivers.

Tagi