Shaft grip for racheting screwdriver from Action (Ø 7.3mm)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Helps with turning the shaft of a ratcheting screwdriver for easier an quicker use
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 14
- Makes
- 0
- Views
- 76
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
This grip is made to make it easier to use the ratcheting screwdriver by turning the shaft separately from the handle.
It is a press fit on the ratcheting screwdriver from the Action stores (shaft diameter of 7.3mm). The part can be scaled in the slicer to fit on basically any model.
I printed in PLA and for easier assembly i put the shaft in the freezer for 10-15 minutes. Even then it is a tight fit but with a few gentle hits from a hammer it goes on. It has to be this tight to keep it from slipping on the shaft.
Some extra info on the screwdriver: as the grip clearly won't fit over the wider end with the hex socket, you need to take the handle off. This model fortunately attaches its shaft with a common square socket which makes this very easy.
Keep this in mind if you use the part on another model as I'm not sure how common a detachable shaft is on these kind of screwdrivers.