SV08 + Beacon3D Rev H mount

Updates

Aug.13.2024: Fully working on stock hardware and even stock firmware! You'll need to hide some .py files to make the [probe] cfg errors go away. I followed this discord user's instructions successfully.

______________________________________________________________________________________
Summary

I want to use the Beacon3D Rev H sensor on my SV08 so I made this mount for it. 
This adapter will require the removal of the rear parts fan as well as some cutting of the toolhead cover. I am not responsible for any damage this causes and it is up to you to determine if this is a good idea. 
_______________________________________________________________________________________________

Hardware

• Beacon3D Rev H (standard)
• M3x8mm BHCS x 2
• M3 Heatset Insert (5mm OD) x 2 

_______________________________________________________________________________________________

Print settings

I recommend printing this out of a heat resistant and rigid material. I chose ABS-CF. 
Use Voron parts settings for good strength. I am using 4 walls and 20% cubic infill. 

_______________________________________________________________________________________________

Config changes

I'm pretty sure I covered everything below, but make sure to follow the official documentation closely and look at any errors you get to know what needs to be changed. 

https://docs.beacon3d.com/quickstart/

This is what I currently have in my beacon.cfg. Basically just matches what I set for my V2.4:

============================================
[beacon]
serial: /dev/serial/by-id/usb-Beacon_Beacon_RevH_[this will be unique to your device]-if00
x_offset: -7
y_offset: 19
mesh_main_direction: x
mesh_runs: 2

[safe_z_home]
home_xy_position: 175, 175 # update for your machine
z_hop: 3

[bed_mesh]
speed: 300                   
horizontal_move_z: 12         
mesh_min: 40,44
mesh_max: 310,314           
probe_count: 30,30           
algorithm: bicubic   
bicubic_tension: 0.4
split_delta_z: 0.016
mesh_pps:4,4
adaptive_margin: 5
fade_start: 0
fade_end: 10
fade_target: 0
zero_reference_position: 180, 180
============================================

In printer.cfg: 

You must comment out the [probe], [probe_pressure], [homing_override], and [bed_mesh] sections in your printer.cfg. Note: Only comment out [bed_mesh] if you put a new one in your beacon.cfg, otherwise just edit it. 

============================================

[quad_gantry_level]          
gantry_corners:              
    -60,-10
    410,420
points:
    50,29
    50,279
    300,279
    300,29
speed: 300                   
horizontal_move_z: 12       
retry_tolerance: 0.0075      
retries: 7                  
max_adjust: 10 
============================================