1 / 1
Skadis T-Clip Zip Tie Holder for small Zip Ties — zdjęcie 1

Skadis T-Clip Zip Tie Holder for small Zip Ties

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Zip tie holder for small zip ties from 60 mm to ~120 mm

Ocena
4,6 / 5
Polubienia
44
Pobrania
287
Wydruki
5
Wyświetlenia
988
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Four different models to store your small zip ties on your Skadis board.

I'm using a shallower version of the Skadis T-Clip System by Line Arc Line.

To attach the zip tie holders to your Skadis board you need the “Skadis T-Clip System - Low Profile Flush Mount Clips” by tchoupshop.

V1: 5 compartments, diameter (inscribed circle) = 26.6 mm, inner heights: 50 mm, 60 mm, 70 mm, 80 mm (title photo)

V2: 4 compartments, diameter (inscribed circle) = 26.6 mm, inner heights: 50 mm, 62.5 mm, 75 mm, 75 mm

V3: 4 compartments, diameter (inscribed circle) = 26.6 mm, inner heights: 50 mm, 62.5 mm, 75 mm, 75 mm

V4: 4 compartments, diameter (inscribed circle) = 28.6 mm, inner heights: 50 mm, 62.5 mm, 75 mm, 75 mm

Tell me, if you want other sizes.

No supports needed if you print them in the same orientation as you would hang them to your board (don't lay them on the flat side that later faces the board).

 

Want a matching desk stand? Check out this file!

Tagi