PetsFang v2 Max Neo Remix (Dual 5015 Fans)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed the PetsFang v2 to fit the Ender 3 max neo. It is not the prettiest thing, but it works. I used the Ender 2 v2…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 220
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Remixed the PetsFang v2 to fit the Ender 3 max neo. It is not the prettiest thing, but it works. I used the Ender 2 v2 baseplate, and modified it to fit the Neo's factory hotend. Then had to modify the Fangs mounting points to fit the Baseplate. I did not change anything with the actual fan ducts.
This is modified to fit the Sprite SE extruder. Had to lose the wire guide mounts in the back. I used the PetsFang ALL_BLT_LEFT_x-48_Y-10_3.29 for the CR touch mount. I cut the middle section out to fit the connector/wires. I bolted only the Left side of the CR touch to the mount. It is a bit bulky and you lose the first 7mm of the bedplate Y axis because of CR touch. I am too lazy to make it work as a right mount CR touch as I dont ever use the full bedplate.
I also included the blender (V4.0.2) file in case anyone wants to make further improvements.
Offsets are X:-62 Y:-13
X- stepper motor End stop position is 7.0. Min position is 7.0 max position is 312
Hardware Needed: Fan Mount Hardware: 4 - 8-32 x 1 Inch machine screws 4- 8-32 nuts
Fangs to Baseplate Hardware: 3 - M4-.7 x 12 machine screws
BasePlate to Ganty Hardware Factory Mounting screw for plastic cover
CR Touch mount to baseplate: 1 - M3-.5 X 10 Screw 1- M3-.5 Nut
HotEnd fan to Baseplate 2 - #4x3/4 screws
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 V2 Neo
No
Supports:
Yes
.2
Infill:
90
Category: 3D Printer Parts
