PetsFang v2 Max Neo Remix (Dual 5015 Fans)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed the PetsFang v2 to fit the Ender 3 max neo. It is not the prettiest thing, but it works. I used the Ender 2 v2…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 13
- Makes
- 0
- Views
- 221
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Remixed the PetsFang v2 to fit the Ender 3 max neo. It is not the prettiest thing, but it works. I used the Ender 2 v2 baseplate, and modified it to fit the Neo's factory hotend. Then had to modify the Fangs mounting points to fit the Baseplate. I did not change anything with the actual fan ducts.
This is modified to fit the Sprite SE extruder. Had to lose the wire guide mounts in the back. I used the PetsFang ALL_BLT_LEFT_x-48_Y-10_3.29 for the CR touch mount. I cut the middle section out to fit the connector/wires. I bolted only the Left side of the CR touch to the mount. It is a bit bulky and you lose the first 7mm of the bedplate Y axis because of CR touch. I am too lazy to make it work as a right mount CR touch as I dont ever use the full bedplate.
I also included the blender (V4.0.2) file in case anyone wants to make further improvements.
Offsets are X:-62 Y:-13
X- stepper motor End stop position is 7.0. Min position is 7.0 max position is 312
Hardware Needed: Fan Mount Hardware: 4 - 8-32 x 1 Inch machine screws 4- 8-32 nuts
Fangs to Baseplate Hardware: 3 - M4-.7 x 12 machine screws
BasePlate to Ganty Hardware Factory Mounting screw for plastic cover
CR Touch mount to baseplate: 1 - M3-.5 X 10 Screw 1- M3-.5 Nut
HotEnd fan to Baseplate 2 - #4x3/4 screws
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 V2 Neo
No
Supports:
Yes
.2
Infill:
90
Category: 3D Printer Parts
