Arcade Push Buttons - 18mm to 60mm Diameter Monster Collection

Please allow me to present:

The 3D Printed Arcade Push Button Monster Collection!

The button widths (diameters) are 18, 24, 30, 36, 42, 48 & 60mm

The control panel or 3DP box material thicknesses catered for are 4, 6, 8, 12, 15, 18 & 22mm

If your mounting material is somewhere between, then I have provided washers of 1, 2 & 3mm

So that you don't need to route massive holes in your control panel I have limited the hole diameters to 18, 24 & 30mm for the rest.

There are 3 parts involved, after deciding the button diameter you require (eg 24) then you need that size push button (eg B24) followed by the matching casing (eg C24) and then whatever the thickness of your mounting material, let's say 12mm. So the two stl files required are: B24_12.stl & C24_12.stl

The third part required is the standard (~28 x 16mm) micro switch.

The idea is that the mounting material is trapped between the lip (or skirt) of the exposed push button and the micro switch below.

I make my mounting holes the size I require (eg 30mm for 30mm push button) but this does make them tight to push in, at times requiring a light sanding, obviously you could cut or print the hole a little wider.

The micro switches fit snugly into the casing but I did provide side holes if you need to screw or wire tie them in.

Any questions or requests, please just ask.

PATREON & PATREON SHOP.
https://www.patreon.com/3DFreeman

Thanks for your continued support!