1 / 5
Development Stand for Arduino GIGA R1 WiFi and GIGA Display Shield — zdjęcie 1
1 / 5

Development Stand for Arduino GIGA R1 WiFi and GIGA Display Shield

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Ease development with the Giga Display by keeping the display and I/O accessible at the same time.

Ocena
0 / 5
Polubienia
15
Pobrania
344
Wydruki
0
Wyświetlenia
1457
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

This is a development stand and enclosure for the Arduino GIGA R1 WIFI and its GIGA Display Shield, based on the basic enclosure provided by Arduino themselves here on Printables.

Although I think it is very clever that the GIGA Display Shield leaves all I/O accessible on the controller, I found that this makes early development difficult, constantly having to flip the device over to see the screen amid all my messy wiring. This makes for a much nicer experience.

There are three options for the backshell: (1) solid except for reset button access, (2) access to available I/O but otherwise closed off, and (3) broadly open allowing the use of additional shields.

This remix of the Arduino original has been redrawn from scratch, and I chose to design the fasteners a little differently than their original. Rather than using through-holes and nuts, my design calls for pressing M3x4 heat-set inserts into the front bezel section, and using M3x20 flat-head cap screws from the backshell side to secure the stack together. I think this is a cleaner look overall.

---

For those who are following my Modular Wind Tunnel for STEM Education, yes – this means I'm hard at work on a standalone touchscreen interface allowing fan speed control, smoke triggering, sensor calibration and data logging: Pitot-static pressures for flow velocity, ambient pressure, temperature, and humidity, plus data from up to 8 load cells for test-article forces and moments. 

I hope to have a demonstration ready for the Tennessee Maker Fest – come check it out!

Tagi