Development Stand for Arduino GIGA R1 WiFi and GIGA Display Shield
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ease development with the Giga Display by keeping the display and I/O accessible at the same time.
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 344
- Makes
- 0
- Views
- 1,457
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
This is a development stand and enclosure for the Arduino GIGA R1 WIFI and its GIGA Display Shield, based on the basic enclosure provided by Arduino themselves here on Printables.
Although I think it is very clever that the GIGA Display Shield leaves all I/O accessible on the controller, I found that this makes early development difficult, constantly having to flip the device over to see the screen amid all my messy wiring. This makes for a much nicer experience.
There are three options for the backshell: (1) solid except for reset button access, (2) access to available I/O but otherwise closed off, and (3) broadly open allowing the use of additional shields.
This remix of the Arduino original has been redrawn from scratch, and I chose to design the fasteners a little differently than their original. Rather than using through-holes and nuts, my design calls for pressing M3x4 heat-set inserts into the front bezel section, and using M3x20 flat-head cap screws from the backshell side to secure the stack together. I think this is a cleaner look overall.
---

For those who are following my Modular Wind Tunnel for STEM Education, yes – this means I'm hard at work on a standalone touchscreen interface allowing fan speed control, smoke triggering, sensor calibration and data logging: Pitot-static pressures for flow velocity, ambient pressure, temperature, and humidity, plus data from up to 8 load cells for test-article forces and moments.
I hope to have a demonstration ready for the Tennessee Maker Fest – come check it out!