Patio/French Door handle hook
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A hook to go on to the handles of a set of Patio/French doors to keep them from blowing in the wind.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 228
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple hook to go on to the handles of a set of Patio/French doors to keep them from blowing in the wind when you don't want the doors fully open.
It was printed using Creality Hyper PLA with the following parameters: -
Standard quality, layer height of 0.2mm, 300 mm/s speed, 0.6mm shell thickness, 15% infill density.
With these settings it should print correctly, although it did feel a bit lightweight in my hand… It's worked fine these last couple of months but if I was to print again I'd use a 0.8mm shell and 25% infill.
When I design a longer version for our other doors I'm going to print it with the above settings to see if I like the feel of that better!
Feel free to experiment yourself with the print settings and show the results.