Patio/French Door handle hook
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A hook to go on to the handles of a set of Patio/French doors to keep them from blowing in the wind.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 48
- Makes
- 0
- Views
- 228
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple hook to go on to the handles of a set of Patio/French doors to keep them from blowing in the wind when you don't want the doors fully open.
It was printed using Creality Hyper PLA with the following parameters: -
Standard quality, layer height of 0.2mm, 300 mm/s speed, 0.6mm shell thickness, 15% infill density.
With these settings it should print correctly, although it did feel a bit lightweight in my hand… It's worked fine these last couple of months but if I was to print again I'd use a 0.8mm shell and 25% infill.
When I design a longer version for our other doors I'm going to print it with the above settings to see if I like the feel of that better!
Feel free to experiment yourself with the print settings and show the results.