1 / 5
Adapter 2 inch (ocular side) to 1,25 inch (telescope side) — zdjęcie 1
1 / 5

Adapter 2 inch (ocular side) to 1,25 inch (telescope side)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Telscope Adapter 2 inch to 1,25 inchFor usage with my 2 inch barlow on my 1,25 inch telescope focuser ;-) Something…

Ocena
0 / 5
Polubienia
1
Pobrania
26
Wydruki
0
Wyświetlenia
146
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Telscope Adapter 2 inch to 1,25 inch

For usage with my 2 inch barlow on my 1,25 inch telescope focuser ;-) Something you would not get very easy to buy.

Print

Rotate, so the 2 inch side is on the bottom. I used a little bit of sandpaper to get the 1,25 side to fit well.

Printed in ASA: I experimented with resizing. I got good results at 101.5 percent. This may vary from material to material and printer to printer.

Test print

Make a test print on the 1,25 inch side IN ANY CASE. Therefore use the test print circle (use a brim) ;-) Check, if the result is OK for the focuser.

Remember: you alway could print a little big bigger and remove material with sand paper, but not the other way round ;-)

Print Settings

Printer:

Anycubic i3 Mega (Model March/2018)

Rafts:

No

**Supports:**

No

Resolution:

0,2

**Infill:**

100%


Notes:

Due to stability use 100% infill!

Category: Physics & Astronomy

Tagi