Adapter 2 inch (ocular side) to 1,25 inch (telescope side)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Telscope Adapter 2 inch to 1,25 inchFor usage with my 2 inch barlow on my 1,25 inch telescope focuser ;-) Something…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 26
- Makes
- 0
- Views
- 146
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Physics & Astronomy
- License
- Creative Commons — Attribution
Telscope Adapter 2 inch to 1,25 inch
For usage with my 2 inch barlow on my 1,25 inch telescope focuser ;-) Something you would not get very easy to buy.
Rotate, so the 2 inch side is on the bottom. I used a little bit of sandpaper to get the 1,25 side to fit well.
Printed in ASA: I experimented with resizing. I got good results at 101.5 percent. This may vary from material to material and printer to printer.
Test print
Make a test print on the 1,25 inch side IN ANY CASE. Therefore use the test print circle (use a brim) ;-) Check, if the result is OK for the focuser.
Remember: you alway could print a little big bigger and remove material with sand paper, but not the other way round ;-)
Print Settings
Printer:
Anycubic i3 Mega (Model March/2018)
Rafts:
No
No
Resolution:
0,2
100%
Notes:
Due to stability use 100% infill!
Category: Physics & Astronomy