MAK Vector - HGX Lite, CR-Touch, Fan Mount

A remix to allow for the use of a HGX Lite (or Sherpa Mini, though untested), CR-Touch with the MAK Vector duct, and adds a mount for a 30mm fan onto the duct.

The mount piece has also been extended slightly for an easier fit of the heatsink.

With the HGX Lite, the fan cover can no longer be used.

You can also combine this model with the original model and other remixes to fit your needs.

Print settings:

This model has been designed for FDM printing. 

Use auto-orientation for the printing orientation.

Clamp, mount

• Material: PLA, PETG, etc. Any non-flex materials should work. Tested with PLA. 
• Layer height: any reasonable height, tested with 0.20mm. 
• Nozzle: any reasonable size, tested with 0.4mm. 
• Infill: 10% or higher. Tested with 15% gyroid infill.
• Bed adhesion: brim is optional.
• Supports: Supports on build plate only can be used for cleaner holes, but not compulsory.

Duct

• Material: PLA, PETG, etc. Any material should work. Tested with PLA. 
• Layer height: any reasonable height, tested with 0.20mm. 
• Nozzle: any reasonable size, tested with 0.4mm. 
• Infill: 10% or higher. Tested with 15% gyroid infill.
• Bed adhesion: brim is optional.
• Supports: Supports can be used on build plate only, and is optional and not needed for most situations.

ABL Mount

• Material: PLA, PETG, etc. Any non-flex materials should work. Tested with PLA. 
• Layer height: any reasonable height, tested with 0.20mm. 
• Nozzle: any reasonable size, tested with 0.4mm. 
• Infill: 10% or higher. Tested with 15% gyroid infill.
• Bed adhesion: brim is strongly recommended.
• Supports: Supports can be used on build plate only, and should be set to ensure that the angled overhang is supported. Might not be compulsory but is recommended due to the otherwise small area of contact with the build plate.

Assembly

Same as the original. 

I've noticed that the duct might not fit as well. This is due to me simplifying the .stl file which might have resulted in some minor inaccuracies (as I do not have a .step or any other easier to edit file). For me, everything still works fine with a little bit of extra (careful) force.

Detailed instructions may be updated here in the future.

Feedback and comments are always appreciated!

This model has been printed and tested by me using Jayo Matte Black filament using above settings on my Bambu Lab A1.