MPCNC Primo SnapOn Drag Chain Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple snap-on supports for the MPCNC Primo to rest a drag chain on.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 92
- Wydruki
- 0
- Wyświetlenia
- 902
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Public Domain
Since the table I built my MPCNC Primo on was a very tight fit I needed a different place to mount the cable chain on.
I took the existing feet and designed a snap fit holder around it which is enough to support an aluminum angle extrusion and the chain.
Disclaimer: This works because I didn't increase the hight of the machine. If you have longer feet there is no groove to snap into.
How to mount: Simply push the holder around the leg (it'll bend but not break) and snap it into place. Then secure it with a zip tie. Don't tighten this too hard or the holder might break. There is no need to make it super tight, you'll see.
PS: I also included a step file if someone needs to make a modification.