1 / 2
eBike battery chargin stand for Shimano BT-E8010
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds the battery neatly upright while charging
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 47
- Wydruki
- 1
- Wyświetlenia
- 642
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (17)Powiązane
A simple stand that holds the battery upright. It might fit some older/newer Shimano batteries too, as long as they fit into the same bike. Open the charging port cover before inserting the battery!
If the stand feels a bit top-heavy with the battery in it, I left a couple open cavities in the bottom to fill with some heavy material like cement, or sand/gravel with glue/epoxy resin or similar.
There's also a cable route in the bottom, if your electric plug is on the wrong side of the stand.
How to print?
- PLA or PETG should both work just fine.
- I designed it to be relatively simple to print, overhangs and bridging used should be trivial for modern printers.
- Have a decent number of perimeters, this will be bumped by vacuum cleaners and shoved aggressively with batteries.
- Infill doesn't probably matter much, as this thing has so much perimeter even in the bottom.