Smooth Anemometer Wind Spinner with Printed Bearings Type 2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A common problem with wind spinners is the friction, which makes the spinners hard to spin, well, problem solved, again!
- Ocena
- 5 / 5
- Polubienia
- 24
- Pobrania
- 124
- Wydruki
- 1
- Wyświetlenia
- 988
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
This project contains ballbeaings, runs very smoothly, no need to purchase extra ballbearings, no extra parts need to be purchased, and minimum support is required.
Quantity to print：
- ball * 20,
- blade * 3,
- blade base * 1,
- head * 1,
- inner_1 * 2 (they are parts of the bearings),
- inner_2 * 4 (2 of them works as parts of bearings, 2 of them works as separators),
- stopper * 2 (to fix the position of the blade rotor ),
- center pole * 2 (one of them works as the vertical pole, one of them is attached at the tail for balance as well as a lock of the tail),
- horizontal pole * 1,
- top_cover * 1,
- tail wing * 1.
Note: each ballbearing requires 10 balls, if your balls are not printed round enough, trim them for better smoothness. Alternatively, use 6mm bb balls for best smoothness. Due to the inaccuracy of the printers, you might need to trim the printed parts if you find parts hard to attach.
You can find ball bearing wind spinnerType 1 here: https://www.printables.com/model/973467-smooth-anemometer-wind-spinner-with-printed-bearin
