LayersFactory
Zgłoś model
1 / 4
Another OpenIPC Radxa GS case — zdjęcie 1
1 / 4

Another OpenIPC Radxa GS case

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mike C

Mike C

@MikeC_11136

This was designed so that it could be used with OpenIPC FPV or RubyFPV GS Software

Ocena
0 / 5
Polubienia
4
Pobrania
56
Wydruki
0
Wyświetlenia
1434
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 4)Remiksy (0)Kolekcje (3)Powiązane

(Work in Progress)

I am making another version (v2) that will have enough room for 2 RTL8812AU's and the front cover with rails for patch antennas clips that also fit on HDZero Rail System.

  • changes in V2
    • removed 3 holes on top
    • add wider holds on top of bottom case for inserts
    • added rail system to top cover similar to HDZero
    • added hole next to fan to route fan wires inside the case

This was designed so that it could be used with OpenIPC FPV or RubyFPV GS Software.

OpenIPC FPV record switch: https://github.com/OpenIPC/sbc-groundstations/releases/tag/zero3w-v1.3.0 

RubyFPV Wiring Diagram: https://rubyfpv.com/hardware.php#buttons 

HDZero Rail Mounts https://www.printables.com/model/392119-hdzero-walksnail-vrx-rail-mount-slidable. I can use my antennas either on my OpenIPC, HDZero, or Walksnail with these.

I wanted to use this for both RubyFPV and FPVUe, in FPVUe, I modified the script so that it would record from the same pin as  RubyFPY Quick Action 1.

To determine gpio_chip and gpio_offset, choose which GPIO PIN# you want to use, on Radxa run the following command:

 

$ gpiofind PIN_32
# This is the values you need to stream.sh file
gpiochip3 18

 

/home/radxa/scripts/stream.sh

#gpio_chip="gpiochip4"
#gpio_offset="10"

# switch to PIN_32 which is also used with RubyFPV wiring for Quick Action 1
gpio_chip="gpiochip3"
gpio_offset="18"

 

#if [ $(gpioget $gpio_chip $gpio_offset) -eq 0 ]; then

if [ $(gpioget $gpio_chip $gpio_offset) -eq 1 ]; then

 

Parts:

Tagi

fpvdigitalopenipc