Tesla (NACS) EV Charger Wall Mount

EV Charger Wall Mount

This mount is compatible with Tesla and NACS EV chargers (Ford, GM, Rivian, Volvo, Polestar, Mercedes, Nissan are all rolling out this charging standard by 2025). It is an assembly of two parts, the wall plate which screws into the wall and the wall mount which slides onto the wall plate.

Printing Guide

It's recommended to print this out of heat resistant materials (ABS, ASA, Nylon and similar). You might be able to get away with PETG in a garage in a cool climate. We recommend printing the wall plate with the larger holes facing the build plate and a small amount of support material at the screw hole edge. The wall mount is best printed with the port facing the build plate, we've found that this print requires no support on printers with sufficient cooling.

Don't have a printer capable of ABS?

Order it direct from us on our etsy shop!

Required Materials

• Wall Plate (printed)
• NACS Wall Mount (printed)
• #6 x 2” Drywall Screws
• No. 2 Phillips head bit
• Drill or Screwdriver
• Stud Finder

Installation

Note: These instructions are for installation in drywall with wood studs

1. Locate a stud
2. Place the wall plate at your desired height on the stud.
   1. The arrow should face up with the arrow side of the plate against the wall
3. Drive a screw through each of the holes. DO NOT overtighten
4. Slide the NACS Wall Mount onto the wall plate from the top

If installing in drywall where a stud cannot be located, use a drywall anchor with the ability to support at least 10 lbs. The screw head must be at least 6mm in diameter.

If installing on exterior masonry or siding, use an appropriate screw for the material and apply sealant to prevent water ingress.