Improved Sand Foot for Packable Camping Chairs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are feet that prevent a chair's legs from sinking into soft ground when weight is applied.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 97
- Wydruki
- 1
- Wyświetlenia
- 422
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
These are feet that prevent a chair's legs from sinking into soft ground when weight is applied. The wide flare creates a higher surface area to allow for a much greater weight before they start to sink into soil or sand. The round tips still provide stable contact points for use on hard flat surfaces.
This scale of this model was specially set to fit the Ozark Trail Compact Camp Chair from Walmart. Therefore the inner diameter (leg hole) is 12.65 mm. To make sure this will fit your brand of camp chair, simply scale the size of the print based on that dimension compared to the diameter of your chair's legs.
Remember that the tolerance is dependent on many factors including your printer and material, so I recommend you print one, or even just the bottom portion of one, in draft mode and test the fit on your chair before printing 4 in higher resolution.
Good bed adhesion is important for this print, especially if you don't have a heated chamber. I use hair spray on a glass bed.
Walls: 4
Infill: 25% Gyroid (but choose what you like best)
Supports: No
My print time was 1 hr 26 minutes on a Voxelab Aquila.