1 / 8
Spiral Fall for Gravitrax - height and rotation angle adjustable — zdjęcie 1
1 / 8

Spiral Fall for Gravitrax - height and rotation angle adjustable

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Gravitrax tile, that spirals down from a high place. Height of the spiral and angle of rotation are adjustable.

Ocena
5 / 5
Polubienia
24
Pobrania
206
Wydruki
2
Wyświetlenia
1069
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Building Toys
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Gravitrax tile that spirals down from a high place to a low place. 
Here are the essential parts : “base”, "top", and three types of ”midele" parts that can be placed in between.

 

The basic concept is as follows:

  1. Fit within the size of one tile as for the XY direction. 
  2. Spin the ball with as large a diameter as possible. - This will give it more presence.- I think this will make it easier to use.
  3. Can adjust spiral's height (and rotation angle) - I made three “middle” tiles of 120, 180 and 240 degrees. Combination of these two make it possible.
  4. Make it printable without support - inspired by excellent design by thomas : https://www.printables.com/model/431159-marbletrack-spiral-gravitrax-compatible

As you create it, you will naturally want to make it higher and higher. 
However, as the ball accelerates while moving through the spiral, dealing with the large centrifugal force from the large diameter becomes a challenge.

Therefore, I added the following two features. I recommend the former to everyone. The latter is more for fun. 

  • Made it possible to store up to 3 balls in the base. I wanted to keep the center of gravity as low as possible, so the lowest ball goes below ground level, but this should not be a practical problem. This counteracts the centrifugal force generated by the fast-moving ball going downward. Personally, if you have extra balls on hand, I think it’s always good to put them in. 
  • Connected the base and top with a core rod - I found that while it sometimes helped to reduce the sway at the top, it also sometimes increased the wobble at the bottom.
    Anyway, the “plug” is used for this purpose. I made it possible to use a 6mm diameter straw as the core rod.

If you drop more than one ball into a tall Spiral Fall at the same time, it can shake a lot more than with just one ball. You should definitely test it out before putting it in your track.

I am a novice with 3D CAD operations, so there were many cases where I couldn’t do what I wanted -  but I think it is easy to use anyway.

There are no particular points to note when printing - but it would be better to increase the infill rate to add weight to the base.

Tagi