Minimized X Shot Hawkeye rear cocking mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
New plunger rod and end cap for a minimized X Shot Hawkeye.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 478
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Indoor Sports
- Licencja
- Creative Commons — Attribution
Cut the blaster at just before the line just above the grip, install the new plunger rod. Cut the rear plates to fit, gluing the right side on the ledge and using it to line up the other side.
Print the plunger rod with 3 walls, 10 top layers, 8 bottom, 15% infill, brim.
Print X2 plates at 100% infill as they will be cut to shape.
ASA is preferred for this application.
I also replaced the stock barrel with ½ CPVC, just had to dremel the plunger tube hole slightly bigger, allowing the barrel to be inset into the plunger itself. I drilled through the end of the CPVC and inserted a piece of filament to keep darts out of the plunger. Expect +15 FPS with this.