Milwaukee Dual Dual Battery Holder Bridge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dual Dual Battery Holder Bridge for Milwaukee Packout
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 74
- Wydruki
- 0
- Wyświetlenia
- 738
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
I liked the dual battery holders, so I printed two (one mirrored), leaving a gap in the middle.
milwaukee packout side mount battery caddy V2.stl
I was concerned a hard wack on the edge might damage them, so I printed this bridge to connect the two and give me a place to do something in the middle. It slides directly in place. I used some 24mm bolts with nuts to lock them in place.
The model provided is FLUSH with the top. I trimmed it so it would look nicer and added bolt holes on the back to make it easier to screw together. You don't need to use them.
For rigidity, I went with 5 perimeters, 30% infill in PETG, at 0.30mm Draft Mode for under 4 hours of print time on my MK3S.