Milwaukee Dual Dual Battery Holder Bridge
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Dual Dual Battery Holder Bridge for Milwaukee Packout
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 74
- Makes
- 0
- Views
- 744
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
I liked the dual battery holders, so I printed two (one mirrored), leaving a gap in the middle.
milwaukee packout side mount battery caddy V2.stl
I was concerned a hard wack on the edge might damage them, so I printed this bridge to connect the two and give me a place to do something in the middle. It slides directly in place. I used some 24mm bolts with nuts to lock them in place.
The model provided is FLUSH with the top. I trimmed it so it would look nicer and added bolt holes on the back to make it easier to screw together. You don't need to use them.
For rigidity, I went with 5 perimeters, 30% infill in PETG, at 0.30mm Draft Mode for under 4 hours of print time on my MK3S.