Sturdy Print-in-Place book stand with page holders V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
New version of my old book stand. It keeps the book from closing.
- Ocena
- 5 / 5
- Polubienia
- 106
- Pobrania
- 280
- Wydruki
- 0
- Wyświetlenia
- 1402
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
Important information before printing
This is a print in place desing, and it's specially designed to be printed with specific parameters, so the hinges work properly.
Layer heigh: 0.2
You'll need:
2 x M5 x 10 mm flat head screws to put them in place. (if you don't have any M5 screws, M4 inserts and M4x8 screws should works too)
Printed in an Ender 3 (bed size: 235 x 235 mm)
Used printing settings
0.2 layer heigh
4 top layers (for better surface quality)
3 bottom layers
3 wall layers (5 gives a better top layer quality. Infill doesn't show through)
20% infill (gyroid)
I don't recommend using supports or rafts. Supports are not needed. Due to the size of the model, rafts are not needed, a good bed leveling should be suffice.