Odroid H2 enclosure

A modern enclosure for this fantastic Hardkernel device with the following features:

• Very tight geometry. 
• Plastic extensions for Power and Reset switches.
• NUC compatible (85mm M3) mounting holes (inserts only) for Vesa Mounting Plate.
• Air ventilation placed where heat is mostly generated.
• Textured enclosure for less 3d printish/more modern look.
• Fasteners: Insert Version (IN) / Self Tapping (ST) version.
• Only 2 external screws + groove/lip for fastening
• Optional multimaterial for Logos and Info, delete them to print recess instead (see sample)
• Placement recess for rubber feet

Printing Instructions

Your printer needs to have good dimensional accuracy and handle 0.2mm tolerances.

• Layer size 0.2mm, 30% infill.
• Print with Front and Back plates on platform (see example)
• No supports 
• Use 2mm brim on the keys

Assembly Instructions

• Install M3 Plastic Inserts (IN version) / See photos
• Install M3 machined screws (IN version) or 3mm self tapping screws (ST version) to attach the PCB
• Top case must first insert horizontal grove, and then slide forward.
• Be careful when placing the key switches in the holders, as they are fragile. 

Note: I have not printed ST variants and monomaterial. Feedback appreciated.