1 / 1
Sharps disposal for X-acto blades -- Spiral Vase — zdjęcie 1

Sharps disposal for X-acto blades -- Spiral Vase

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A simple sharps disposal container that perfectly fits #11 hobby knife blades (x-acto type). Prints in 10min on MK3S+.

Ocena
0 / 5
Polubienia
7
Pobrania
17
Wydruki
0
Wyświetlenia
192
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Share Alike

I like to change out my knife blades early and often, but they are awkward to throw away.

This simple sharps disposal container fits about eight standard #11 hobby knife blades. They blades will just fit in the slot, and won't come back out. It uses very little material and prints in about 10min in spiral vase mode. So once it's full, you just throw the whole thing in the bin without fear of slicing open your trash bags!

I've included a .3mf file that is setup to print both parts in one job sequentially as a spiral vase on a prusa mk3s+, but you can print the parts separately as well.

The tolerances are very tight but work well for my mk3s+ with generic PETG material. The cap should fit very snugly within the box; the ridges of the filament layers should interlock to form a grippy seal, and it should be difficult or impossible to separate them once connected. Adjust the X and/or Y scale of the box component if necessary. If the blades don't quite fit in the slot, adjust the X and/or Y scale of both the box and cap.

It is very important to use Spiral Vase mode, otherwise the cap will come out as a solid chunks of plastic.

Tagi