LM8UU Superlube Grease Linear Bearing Lubricator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the LMU Bearing Grease Packer with a strong 8mm nut on the end to hold the bearing in place
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 78
- Wydruki
- 2
- Wyświetlenia
- 559
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is a remix of the LMU Bearing Grease Packer with a nut on the end to firmly hold the bearing while packing it with grease.
While I liked the design, I had some frustration with the 4mm thread, finally cross-threading it.
I copied the existing design of the Superlube tube thread.
The lubricator worked well on 10 x LM8UU bearing for my MK3.
Some patience is required as the Superlube take a little time to find its way all the way through.
I found that 6 x 10 seconds firm squeeze sessions were required to complete the lubrication.
After reading a comment that a Superlube tube had sprung a leak at the base of the tube, I squeezed from the base of the tube and worked upwards.
10 bearings appeared to use approximately 20% of the grease in the tube as can be seen in the photo of the tube after lubricating 10 bearings.
I printed these in PETG, 0.15mm, 20% infill,but any standard print should work.
STEP files are provided for anyone wanting to tweak the design.