RAK 19003 and GPS module case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for RAK 19003 carrier board with space for GPS module and antenna.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 102
- Wydruki
- 1
- Wyświetlenia
- 823
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is simple case for RAK mini base board, 19003, with two versions.
One is thinner, which cannot accomodate GPS module and antenna, and second one (3mm thicker) with space for mounting GPS module and it's antenna (which is glued in space near top).
Bluetooth antenna is just glued on side wall where you find place…
If you wish, you can install BL-5C battery, but wires needs to be soldered (not ideal, but I went for most minimalistic case possible).
Design requires no additional mounting hardware beside 3 screws that came with baseboard, and lid is held in place with pegs(?).
Each case has 3 files, base plate (to mount RAK base board), case and lid.
I printed it with 0.6 and 0.4 mm nozzle, with 0.28mm layer height and 0.66mm layer width, but there is nothing specific in design.