Honeycomb wall (HCW) for Prusa Mini Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The largest Honeycomb Wall (HCW) segment that can be printed on a Prusa Mini that attaches to Prusa Mini Enclosure.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 46
- Wydruki
- 2
- Wyświetlenia
- 460
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update
I'm removing the part for the left wall.
I have noticed that the holes in the walls of the enclosure are not symmetrical. I have used a hole for the spool holder which does not exist on the left wall.
Mounting
You will need at least two M3 screws and one M3 nut (see picture):
- one M3x8 (or longer) and one M3 nut for the bottom mounting hole
- one M3x16 (or longer) to replace the spool holder screw
If you installed enclosure handle, the M3x12 that holds it is long enough to secure the HCW module in addition to the handle. Otherwise you need another M3x8 (or longer) + M3 nut combo.
Limitations
It wasn't my intention to cover the whole side of the enclosure and it is impossible to print a HCW segment bigger than this one on a Prusa Mini.
Printing
No supports are needed.
I suggest printing with the outside (visible) surface on the plate so you end up with the nicest possible finish. I made sure the holes for screws will print fine without supports – see picture.