TUSH - One Piece "Push" Version
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a one piece version of Tush.
- Ocena
- 4,909 / 5
- Polubienia
- 38
- Pobrania
- 319
- Wydruki
- 11
- Wyświetlenia
- 1736
- Oceny
- 11
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is a one piece version of Tush. Bearings (608's) are pushed up through the holes in the bottom of the bracket and then they snap in place.
It takes a little concentration to get them snapped into the center of the bearing. They snap easily over the outer race, but get a little tougher snapping into the inner race.
Bearings can be removed by continuing to push up out of the snap features.
I kept the infill low to allow better flexing of the snap features.
Also attached is the step file for the bracket.
Print instructions
Category: 3D Printer Accessories Print Settings
Printer Brand: Prusa
Printer: i3 MK3
Supports: No
Infill: 20%