1 / 6
TUSH - One Piece "Push" Version
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a one piece version of Tush.
- Rating
- 4.909 / 5
- Likes
- 38
- Downloads
- 319
- Makes
- 11
- Views
- 1,736
- Reviews
- 11
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
This is a one piece version of Tush. Bearings (608's) are pushed up through the holes in the bottom of the bracket and then they snap in place.
It takes a little concentration to get them snapped into the center of the bearing. They snap easily over the outer race, but get a little tougher snapping into the inner race.
Bearings can be removed by continuing to push up out of the snap features.
I kept the infill low to allow better flexing of the snap features.
Also attached is the step file for the bracket.
Print instructions
Category: 3D Printer Accessories Print Settings
Printer Brand: Prusa
Printer: i3 MK3
Supports: No
Infill: 20%