S400 Mini-ITX Case - Vertical Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
S400 Mini-ITX Case stand to prop the case up vertically to save even more space on your desk
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 446
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a vertical stand for the S400. I could see a few for the S300 but decided I'd just make my own one for the S400 case as well. The vertical stand saves even more space on the desk than what this tiny PC case already saves in terms of surface area but does mean that all the cables will be sitting out from the top of the PC and it will increase the height profile.
Printed on an Ender 3 V2 Neo.
Print takes up near enough the whole bed when printing on the Ender 3 V2 Neo.
Printed 'upside down' so that the feet face upwards off the print bed. Standard supports used in Cura.
I've printed this using PLA + with 50% infill and seems to do the job. Cannot personally attest to less infill density resulting in similar durability but you can probably get away with it.
Despite having used PLA+ myself when printing this model, even when the computer is under serious loads I've not seen any deformation due to thermal elasticity. If you want to be on the safe side then perhaps printing in PETG or something more heat resistant is the way to go but again mine has been completely fine in PLA+ (approximately 8 days thus far with no signs of deformation).
It is a pretty snug fit to the PC case but I designed it this way on purpose as I would rather that and know that the PC isn't going to fall out of the thing!