MacBook Vertical Stand (With Magnets)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Identical to the "Clamshell Macbook Stand" but I also added 4 slots for adding magnets mid print to help prevent sliding
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 208
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
Identical to the "Clamshell Macbook Stand" but I also added 4 slots for adding magnets mid print to help prevent the stand from sliding around.
Was going to add slots for rubber feet to further prevent sliding, but sanding the bottom with a low grit sandpaper did the job well enough.
Magnet dimensions: 15mm x 1.65mm
Print Settings
Rafts:
No
Supports:
No
Notes:
Add a stop at layer 15 to insert the magnets.
Can easily be done in Cura via the Post Processing plugin"Pause at Height".
To enable go to: Extensions > Post Processing > Modify G-Code > Add a script > Pause at Height
Then change the settings to the following: **Pause at:Layer Number* **Pause Height:15* **Method:(Use whatever your printer is. My Ender 3v2 has Merlin 2 installed, so that's what I used)* **Retraction:(I used 12)* **Extrude Amount:***(I used 7)*
You could also set'Standby Temp' if you wish to prevent the nozzle from cooling down, I did.
Category: Computer