Wera Kraftform Micro Compact Holders for Wall Control
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This adapts the Kraftform Micro holders by Snajo and Craig and pushes them closer together, saving a little board space
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 265
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This uses the DDD Printable Wall Control System (github) to mount Kraftform Micro screwdrivers onto a wall control surface.
I didn't use support for printing and used PLA with 20% gyroid infill.
For the sidepieces I used the 2x0 Flat (Left and Right) models. Then use four 4x10x8mm pins to attach the sidepieces and the mount. If you'd like to secure from vertical movement, use the 3x0 Flat sidepieces and then also print a locking spacer of the same width to mount above or below the mount. Then print threaded pin(s) to secure the spacer. I print the threaded pin at 97% size in X-Y dimensions to thread it more easily.
I have also mounted this on 1" wood pegboard using the sidepieces in this model.