Auto-Rewind Wall-Mounted Drybox
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of Prusa drybox to support auto-rewind, PTFE tubing and desiccant packs.
- Ocena
- 5 / 5
- Polubienia
- 64
- Pobrania
- 303
- Wydruki
- 3
- Wyświetlenia
- 3151
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I like the straight design of Wall-mounted Prusa Drybox with humidity sensor. It lacks some features like auto-rewind and support for PTFE tubing though. So I added the following:
- Support for Integrated Auto-Rewind spool holder by VincentGroenhuis https://www.thingiverse.com/thing:3781815 as first done by rpgweb https://www.prusaprinters.org/prints/58523-standalone-drybox-with-auto-rewind-support
- Compartment for desiccant/silica packs
- Filament feed through PTFE tubing attached with a PC4-M10
- Gasket - as I noticed that humidity was still an issue with sensitive filaments as TPU or Nylon
To build this you need
- Vincent Groenhuis parametric auto-rewind system (minus shaft)
- 100 mm shaft by rpgweb (see files for a combined 3mf)
- Top & Bottom housing (needs to be rotated sideways to fit print bed)
- Lock
- Gasket is optional
- Screws: 1x M3x5 / 1x M3x10 / 2x M3x30
- PC4-M10 fitting
- PTFE tubing
Top and Bottom parts of the box should be printed with PLA for minimal warping. Gasket printed with TPU. Everything printed at 0.2mm layer height without supports.
Take care to screw in the fitting perpendicularly to the thread! It might be damaged otherwise. I inserted an Allen key through the hole for proper alignment.
Original build instructions https://blog.prusaprinters.org/dryboxes-and-alternative-spool-holders-not-only-for-multimaterial-upgrade