1 / 4
Sovol Sv07+ filament sensor to extruder relocation + m10 PTFE fitting — zdjęcie 1
1 / 4

Sovol Sv07+ filament sensor to extruder relocation + m10 PTFE fitting

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Can be used to mount the filament sensor to the extruder if you want to use my filament guide or use a PTFE tube

Ocena
0 / 5
Polubienia
12
Pobrania
81
Wydruki
0
Wyświetlenia
422
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

When printing put small supports under the screw holes. For the relocation you can route the original sensor cable or you can make your own small adapter that uses the port on the extruder. I had only one JST XH 3pin connector but you need two to make the adapter so i found a STL for the pin on thingiverse and printed the other because i had hard time finding them. In the Config file for the SV07+ under the [filament_switch_sensor my_sensor] i had to change the filament sensor pin from PD11 to PB0. The PTFE fitting hole might need to be shaped with a knife.

Tagi