1 / 7
Hybrid Vented/Solid Betweener for JC's Creality K1 Lid Riser — zdjęcie 1
1 / 7

Hybrid Vented/Solid Betweener for JC's Creality K1 Lid Riser

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Creality K1 Riser betweener with vents that open/close by sliding a toggle.

Ocena
4,875 / 5
Polubienia
102
Pobrania
898
Wydruki
9
Wyświetlenia
2400
Oceny
8

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

The Hybrid Betweener

Tired of having to swap betweeners depending on the material you are printing and its ventilation needs? And where do I keep the spare betweeners when they are not in use? This project aims to provide the only betweeners you'll ever need.

These betweeners print in two parts – an outer shell that slots into the riser corner pieces, and an inner core that slots into the shell. The result is a betweener with ventilation holes that can be opened/closed easily by sliding a toggle.

Printing:

I printed these in PLA, but I expect other materials would also work fine. Each betweener is an assembly of two parts:

  • Outer Shell: 
    • Print orientation: Because of its inside slot, the “shell” part must be printed in the vertical orientation.
    • Supports: this part printed just fine without supports, though I did opt to add a brim to ensure good build plate adhesion due to its small footprint.
    • Infill: I printed these at 100% infill, though you could probably reduce that without compromising the part.
    • Wall Loops: 3
  • Inner Core: 
    • Print Orientation: The core should be printed laid flat on the plate, toggle fin facing upwards
    • Supports: No supports needed
    • Infill: I recommend printing these at 100% infill.
    • Wall Loops: 3

Assembly:

Pretty self explanatory. Just slot the core into the shell from the top, lining up the core's toggle fin with its cutout in the shell.

Tagi