Filament Feeder Guide Mount for Prusa XL from Dry Box to Printer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy way to load and see what colors you are running with 90% of your filament covered from dry box to printer.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 673
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I struggled with finding the perfect solution of running my ptfe tubes from my dry box which is under my table to the printers. Using standard 4mm od 2mm ID caused to much friction and the extruders could pull it through. I switch to 4mm OD 3mm ID and it got better but this tubing was to flex able which caused some issue, and it was hard to feed the filament into the sensor because the ID was to big so it wouldn't line up right. Not to mention trying to feed filament from that far and then through a sensor and all the way to the extrude was tough. I went back and forth between using a magnetic break so everything was cover or my current design. I choose the current design because i think being able to see at a glance what colors are where and the ease of having everything hard mounted was a lot nicer. This design is extremely simple but effective.
Hardware Needed
Hardware needed is the spool mounting hardware that comes with the XL. I imagine if you're installing this, you're not using the Spool holders. I repurposed my ensy spring nut and screw to mount mine to the rail of the machine. The screw holes are offset so once mounted it lines up with the edge of the printer.
After that you will need 10 PC4-M10 fittings and 5 PC4-M6 fittings which you may not need those 5 if you have fittings in you dry box already.
I then ran 4mm OD 3mm ID from the dry box to the filament feeder mount and from the mount to the machine i used 4mm OD 2mm ID ptfe so it would line up with the sensor. of course, you could use capricorn ptfe if you want. Its up to you I'm just saying what I did which gave me good results.
material and settings
PLA and standard setting for .2 layer height
I hope this can help. happy printing