1 / 4
Jeep Wrangler YJ - Fender Flare Nut Spanner + 13mm Hex Adapter — zdjęcie 1
1 / 4

Jeep Wrangler YJ - Fender Flare Nut Spanner + 13mm Hex Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Spanner to aid in the removal of the fender flare nuts - also includes an adapter for a 13mm hex socket / spanner

Ocena
0 / 5
Polubienia
7
Pobrania
24
Wydruki
0
Wyświetlenia
158
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

Just a spanner I whipped up to aid in the removal of fender flare nuts on my 1994 Jeep Wrangler YJ.

Has a hole down the middle for the tip of self tapping screws to poke through. Small fillets down side to aid in comfort if holding.

I have also created a little hex head adapter for either a 13mm socket or spanner.

Part group: EYJ-205

Part number: J400 4868

Onshape Link Here

 

For both I'd recommend printing them at an angle (so the layer lines are not parallel to the direction torque is being applied). Though given that these shouldn't be heavily torqued it's more a safety net for corroded fasteners.

Infill should be fairly high as well for the same reason.

Supports are naturally required if you're printing at an angle - mandatory for the hex adapter but if printing the spanner flat then it'll be fine without supports.

Tagi