Airbrush BSP 1/8 Male to 1/4 NPT Male Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick fix for an airbrush connection.
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 184
- Wydruki
- 0
- Wyświetlenia
- 705
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
I had an impossible time trying to find any BSP fittings in my area. As my new airbrush had just arrived with the wrong hose, I was in a jam. Luckily there were ¼ NPT fitting plugs and 1/8 BSP fittings I was able to find to put together. I added a small 0.5mm plate at the bottom to negate any stability issues. This should not need any supports. Just cut the plate off the bottom. If you prefer, use the cut option at 0.5mm and get rid of the plate. I recommend melting any stringing inside your model after it prints with a heat gun or lighter if they occur to keep them from going through your airbrush. You'll want to use some teflon tape, mine works quite well, but it was a bit leaky at first.
I printed this at 0.15mm layer height entirely in perimeters (Print Settings - Layers and Perimeters - Vertical Shells box - Perimeters) I set this value to 50 on this one; as long as it's higher than how many perimeters it takes to get through the model, it will print everything in perimeters. I find this setting makes very strong parts.