Snapback Hook/Hanger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A very simple (and probably overkill) little mount to easily hang Snapbacks on your wall.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 74
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial
To properly hang Snapbacks from this, the snap-back has to be slid into the hanger on either thin side and then adjusted to the center so the overlapping parts prevent slipping out (see picture 2 (also excuse my disgusting walls))
The opening is meant for just regular cheap drywall screws (PH2 3.9mm x 25mm) since I have severe trust issues with double sided tape but if that is not something you struggle with, I would imagine that works just as well.
I printed mine in PLA with fairly standard settings and I don't think material choice or settings matter a whole lot for this.