Zero G Mercury Revo Hemera XS Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This will allow you to mount a Hemera XS extruder onto a Ender 5 Plus that has the Zero G mercury upgrade
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 198
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Note this is a work in progress. While it does work, it does have room for improvement.
This will allow you to mount a Revo Hemera XS Extruder onto a Ender 5 Plus that has the Zero G mercury upgrade.
I printed my parts using ASA as I did with all my other mercury parts.
This will print with 5 parts
Hemera Mounting piece
Bl touch mount Modified
Trihorn Duct modified which is now in 2 pieces.
X Sensor Mount Modified
You will have to physically change a few things on the printer to make room for the Hemera Extruder as it sticks out more to the front.
Move the Lineral Rails for the Y axis all the way to the back, you will have to move the Y Axis end stop back further as well.
These are the M851 settings that worked for me however I would recommend changing the Z offset until you get it tuned it as it could be too closer for your setup.
M851 X-37.00 Y35.00 Z-3.58
If you are using their hot pack with the 104NT sensor you will have to change your senor type to #5 in the firmware. (If using Marlin)