1 / 6
Pelton Fan Duct V1 for Ultimaker 2 / 2+ (ready for dual extrusion!) — zdjęcie 1
1 / 6

Pelton Fan Duct V1 for Ultimaker 2 / 2+ (ready for dual extrusion!)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Optimized fanduct for the Ultimaker 2 /2+ series. Ready for Dual Extrusion

Ocena
0 / 5
Polubienia
8
Pobrania
47
Wydruki
1
Wyświetlenia
596
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

A fan duct for the Ultimaker 2 by PeltonEngineering!

Uses the fans airflow far better then the original one. I tried to optimize the cooling as much as possible. Also you need no screws for it.

IMPORTANT: You have to print the Y-Axis switch adapter, to prevent the printhead from smashing against the wall. It reduces your effective building space for about 4mm, but I think this is reasonable, for the possibility of printing awesome overhangs.

If you got any thoughts about it, let me know in the comment section!

Tagi